Record the design baseline

A DFM review should name the part revision, material, shrinkage assumption, expected machine and the files reviewed. This prevents later decisions from being detached from the data that produced them.

Separate confirmed customer requirements from engineering assumptions and open questions. Each unresolved point should have an owner and a date for closure.

Review visible and functional risk

Mark parting lines, gates, ejector contact, weld lines, sink-sensitive areas, texture boundaries and possible distortion. Relate each observation to its product impact instead of presenting a disconnected list of moulding rules.

For every recommendation, show the proposed change, the reason, the expected benefit and any trade-off in appearance, strength, cost or timing.

Close the review with decisions

A useful DFM document ends with accepted actions, rejected actions and risks carried into tool design or trial. Images and section views should be revision-controlled so that approval is unambiguous.

The output becomes an engineering record that connects product intent to the mould concept and later validation evidence.